Activate login mode: Smart motion detector
You can register up to 20 devices directly on the Smart motion detector. To log in, you must activate the log-in mode on both devices.
- First switch the device to be registered to registration mode. Please refer to the operating instructions or the FAQ section of the respective device.
- Then press the Auto and the On/Off button simultaneously for about 1 second. The LED will briefly flash green and then light up green for a few seconds if the login was successful.
Basic notice:
The Smart motion detector can be directly connected to up to 20 Smart light receivers. As soon as the Smart motion detector detects a movement, the registered actuators are also switched on and
switched off again after the movement has passed. The registered actuator does not need to have its own staircase staircase function must be switched on at the registered actuator. The automatic timer must be switched on for the registered actuator so that it reacts to the automatic timer. This is the case at the factory for all actuators.
If the on/off button is pressed on the Smart motion detector, all registered actuators are also switched.
Key combinations for the following settings:
Sensitivity
Press for 4 seconds
Brightness limit value
Press for 4 seconds
Run-on time
Press 4 seconds
20 seconds 30 minutes