Registration of addZ LED Smart bulbs on the Premium gateway (the same applies to other Zigbee bulbs)

Y. Beenen

Prerequisite

Premium gateway with current firmware
addZ stick is plugged into the Premium gateway
addZ LED Smart bulb or other Zigbee light source is in delivery state (the delivery status can usually be recognized by the fact that the light source flashes or lights up in all colors when the voltage is switched on. Information on resetting the addZ light source can be found in this article).
Distance from the addZ LED Smart bulb to the Premium gateway or to other consumers with Zigbee technology is not too large.

Start the login mode at the Premium gateway, select Devices > Login devices and start the login mode.
Switch on the power for the addZ LED Smart bulb. The addZ LED Smart bulb must display several colors in succession and then flash briefly to acknowledge.
It may take up to 3 minutes to find all new addZ LED Smart bulbs. If many bulbs are to be registered at once and they are not displayed after 3 minutes, please stop the registration mode of the Premium gateway and start it again.
If the addZ LED Smart bulbs are not found, switch the power of the addZ LED Smart bulbs off and on again.
Assign a suitable name and description for the addZ LED Smart bulb.

The addZ LED Smart bulbs are now displayed in the device category "Lighting" and "All devices".