Activate login mode: Smart motion detector
You can register up to 20 devices directly with the Smart motion detector. To register, you must activate the registration mode on both devices.
- First switch the device to be registered to registration mode. Refer to the operating instructions or the FAQ section of the respective device.
- Then press the Auto and On/Off buttons simultaneously for about 1 second. The LED will flash green briefly and then light up green for a few seconds if the registration was successful.
Basic notice:
The Smart motion detector can be connected directly to up to 20 Smart light receivers. As soon as the Smart motion detector detects a movement, the registered actuators are switched on and switched off again after the movement has passed.
No separate staircase function has to be switched on at the registered actuator.
Staircase function must be switched on. The automatic timer must be switched on for the registered actuator so that it reacts to the automatic function. This is the case in the factory for all actuators.
If the ON/OFF button is pressed on the Smart motion detector, all registered actuators are also switched on.
Key combinations for the following settings:
Sensitivity
Press for 4 seconds
Brightness limit value
Press for 4 seconds
Run-on time
Press 4 seconds
20 seconds 30 minutes