Registration of the addZ LED Smart bulbs on the Premium gateway (the same applies to other Zigbee lights).

Y. Beenen

Prerequisite

Premium gateway with current firmware
addZ stick is plugged into the Premium gateway
addZ LED Smart bulb or other Zigbee lamp is in the delivery state (the delivery status can usually be recognised by the fact that the light source flashes or lights up in all colours when the power is switched on. Information on resetting the addZ light source can be found in this article).
Distance from the addZ LED Smart bulb to the Premium gateway or to other consumers with Zigbee technology is not too great.

Start the registration mode on the Premium gateway by selecting Devices > Register devices and starting the registration mode.
Switch on the voltage for the addZ LED Smart bulb. The addZ LED Smart bulb must display several colours in succession and then flash briefly to acknowledge.
It may take up to 3 minutes to find all new addZ LED Smart bulbs. If many lamps are to be registered at once and they are not displayed after 3 minutes, please stop the registration mode of the Premium gateway and start it again.
If the addZ LED Smart bulbs are not found, briefly switch the power of the addZ LED Smart bulbs off and on again.
Assign a suitable name and description for the addZ LED Smart bulb.

The addZ LED Smart bulbs are now displayed in the device category "Lighting" and "All devices".