Activate login mode for the Smart sun sensor (direct login to receivers) - Initial commissioning
General:
- The Smart sun sensor is supplied with an inserted CR 2450 battery, which is secured with a separating foil. Carefully remove the separating foil from the device. It is not necessary to open the device. Afterwards, all LEDs light up once briefly.
Logging on to the desired unit:
The Smart sun sensor can either be registered directly with up to 5 receivers for sun protection or with the Premium gateway. Information on registering with the Premium gateway can be found here.
-
- Set the device to be registered, such as the wireless roller shutter motor or one of the tubular motor actuators, to registration mode.
- Then press the menu button on the side of the sun sensor until the menu LED lights up blue.
- Tap the + button once, the status LED flashes green and switches to permanent green for a few seconds if the registration was successful.
- The roller shutter that has been registered will move up briefly for acknowledgement.
- The registration is now complete.
Fastening the sensor to the window pane:
-
- The Smart sun sensor is stuck to the window pane relatively far down. The sensor must not be covered later when the blind moves into the sun position.
- The sensor can be mounted vertically or horizontally.
- The operating buttons should be on the left or on top.
Set the sun function:
-
-
Setting the limit value
- You have two options for setting the sun sensitivity. The easiest way is to attach the sensor to the window pane and then accept the currently measured value as the limit value for the desired sun. To do this, press the menu button repeatedly until the LED lights up yellow. Then press the Menu and Plus keys simultaneously.
Alternatively, you can also set the sensitivity manually in the sun menu. To do this, press the menu key repeatedly until the LED lights up yellow, then simply tap the plus or minus key until the desired value is displayed via the LEDs. The LEDs indicate 10 steps with 5 LEDs. If the LED flashes, it is half a step, if the LED lights up, it is a whole step. - A green status LED serves as a check. If the set limit value is below the currently measured value, the LED lights up green.
- You have two options for setting the sun sensitivity. The easiest way is to attach the sensor to the window pane and then accept the currently measured value as the limit value for the desired sun. To do this, press the menu button repeatedly until the LED lights up yellow. Then press the Menu and Plus keys simultaneously.
-
-
-
Preparing the units
- Before proceeding with the next steps, please check the configuration of the units that are to be controlled by the sun.
- For some devices, the appropriate sun mode must still be set. For the Smart programmable timer premium and the RolloTron smart flush-mounted belt winder premium, mode 3 must be set in menu 9-9-3.
-
-
-
Adopting the sun position
- Move all registered devices to the desired sun position.
- Press the menu button on the sun sensor until the LED lights up yellow.
- Press the menu key and the minus key at the same time.
- All motors jerk briefly as an acknowledgement, switch on the sun control and set the current position as the sun position.
-
-
-
Testing the sun function
- Open all registered sun shades completely.
- Tap the menu button on the Smart sun sensor until the LED lights up yellow.
- Press the Plus and Minus keys simultaneously.
- All roller shutters move into the set sun positions.
-